ex VAT:£100.92
Need to replace your shed roof? Our quick and easy to install replacement rubber roof kits are the ideal solution for long term waterproofing your shed roof
6ft x 10ft Apex Shed Roof Kit (2.5m x 3.3m)
Sheds are an important part of our home, often storing expensive equipment like mowers and strimmer’s. Yet all too often they rely on cheap, thin felt to keep them weather tight. Well, not any more! We have standard size rubber roofing shed roof kits compromised EPDM Rubber roofing membrane sheet and the adhesive to complete the job.
Our rubber roofing shed kits are ideal for new builds as an upgrade to the provided felt or as a replacement roof for existing sheds
Shed Kit Contains 2.5m x 3.3m of 1.14mm Shed Rubber EPDM Membrane Sheet Water Based Deck Adhesive and an adhesive roller Instructions
Our Rubber Roof Kits are designed to fit standard garden shed sizes. Whilst we have allowed enough excess membrane to the width and length, please check the sizes against your own shed as sizes differ between shed manufacturers.
Weight
16 kg
Brand
Shed Rubber
Carefully remove the existing timber edge trims (fascia’s). Put them to one side if they are in good condition so you can re-fit them later.Remove the old roof covering (usually felt), remove any exposed nails, all sharp surfaces and repair/replace any rotten deck boards. We recommend using OSB3 board if you need to fully replace them.
Ensure that your deck surface is clean, dry, frost free and free from dust, grease, loose material and other contaminants. Unwrap the EPDM Rubber Roof Membrane and place unfolded on the shed roof, ensuring you have equal coverage. Wait for approximately half an hour for the EPDM to relax.
Fold back half of the EPDM Rubber Roof Membrane onto itself to expose the timber deck underneath. Apply the WBA Deck Adhesive evenly over the roof deck with the Roller supplied. With the adhesive still wet, roll the membrane back into position using a soft broom to ensure no air is trapped underneath the membrane and to ease out any creases. Repeat the process for the other half of the roof.
Cut off any excess EPDM Rubber Roof Membrane using sharp scissors or a knife leaving approximately 50mm overhang. Fold the membrane back on itself and fix using galvanised clout nails or with a timber batten
ex VAT:£100.92
){kind=link}